I am much more than a designer and manufacturer of crushers.

In fact, to service the mining and aggregate industries, operate 20 hours per day, 6 days a week manufacturing, assembling, fabricating, welding, machining and babbiting for their customers world-wide.

Just some of the specialties that I have developed over the years include the manufacture, component repair and parts supply for large equipment aggregate and other heavy industries.

Also uses many pre-qualified welding procedures developed in-house to manufacture any type of new steel or stainless steel fabrication.
In addition to these steel fabrication processes they are also qualified and equipped for most cast iron and manganese repairs.

Actually I use of the largest boring mills in Italy.
Their Vertical Boring Mill has the ability to turn large diameters up to 7 mts x 2 mts high.

When it comes to babbiting, the company has the capability to babbitt all new or used bearings using any type of babbitt that a customer requires.

Another of the company's specialties is the manufacturing of the double toggle to increase the productivity of the jaw crusher.

The 48 x 80" Deep Frame Jaw Crusher was redesigned by to accommodate fabricated design versus the old casting type of crusher.

This, over the years has proven the true strength in design that is required when a tough, hard and/or abrasive crushing is the makeup of rock.

With double toggle Jaw Crusher, liner changes and downtime is greatly reduced because this crusher is not hampered by the rubbing and scrubbing motion caused by single toggle crushers.

The above mentioned rubbing and scrubbing in the crusher chamber is what leads to excessive premature wear on their manganese.

As impact is what hardens manganese this is an important feature of the double toggle crusher.
Other features include:
Removable greasable toggle ends
High tensile fully machined all over Manganese steel or bronze toggle seats
Easy adjustment for discharge setting and stroke adjustment to suit the material
When Babbitt bearings are used, there will be no bluing of shaft in the babbitted bearing.